Make a simple cone shaped ring keeper from marbled air hardening clay, with a touch of sparkle.

The air dry clay used for this project was provided for me by Cass Art

If you like are like me and like to take your rings off when washing up, washing your delicates by hand or just at night when you go to bed, then you need a safe place to keep them. I've been using a little ring dish for the last few years but when I received some air hardening clay from Cass Art for their #BeInspired campaign, I thought I'd try making something new.

I'd seen some ring cones in the shops a while ago and though this simple shape might be easy enough to make from clay for a beginner like me. It was! 

You can find details of the materials I was given by Cass Art here in my post about the Marbled Jewellery I made first.

How to make a ring keeper from air dry clay

To make a clay cone shaped ring keeper you will need:

• Clay - mine is DAS air hardening clay

• Marbling Mix - again mine is from DAS

• A piece of scrap card to form a cone mould

• A sharp knife

• Varnish - mine is Vernidas from DAS, this Sculpey one is similar

• Glitter, I can’t find one online exactly the same as the one I used but this one would make a great substitute.

Create the cone shape from the clay

You can just freestyle rolling a cone shape from your air dry clay. If you are able to get a good shape that way then that would be the simplest method. I tried a couple of times and my cone was always a little lopsided so I made a cardboard mould which I found worked better.

To make a cardboard mould, roll the scrap card into a cone and secure with tape. Ideally use card that is glossy and roll so the glossy side is inside.

Marble a lump of clay using the marbling mix.

Push the clay into the cone, really squishing it in there to get as many air pockets out as possible.

Cut the tape and unwind the card from the clay.

Wet your fingers with a little water and smooth the cone, you can roll it gently as well to remove any creases and improve the shape.

Cut off the excess with a sharp knife making the bottom level.

Roll and smooth it again just to make sure you are happy with the shape.

Leave to dry and harden - this took about 2 days.

Varnish and decorate the ring keeper

Varnish and leave to dry.

Apply another coat of varnish this time concentrating round the bottom of the cone, just dabbing a little varnish here and there as you go towards the point. You are basically using the varnish as a glue.

Holding the cone over a plastic container sprinkle with glitter.

Leave to dry again, I found it easiest to pop it in a cotton reel.

Once dry, brush off any loose glitter and then cover the whole cone with one last coat of varnish to seal and stop the glitter leaving a trail wherever it goes.

Of course the glitter element is entirely optional. I just fancied a little sparkle. You could mask off part of the cone and spray paint a section, or real gold leaf just dabbed here and there would look fabulous. Or you could just leave the marbled effect of the clay, which is really pretty by itself.

I've been using this for a few weeks now and I have to say it's actually easier that a little ring dish, you can pick your rings up in a stack and just pop them on the right fingers so quickly - I think I must be saving at least 2-3 seconds every day. At this rate I'll have an extra 15 minutes or so every year, what on earth will I do with all that extra time! 

I’ve made a few other items from air dry clay over the years, which you might like to check out.:

Julie

I’ll be sharing this idea at these link ups